Print settings
| Material | PETG |
|---|---|
| Layer height | 0.2 mm |
| Infill | 40% |
| Supports | Not needed — prints flat as oriented |
| Filament | ≈ 7 g total (estimate) |
| Size · filament-guide-608-bearing-2020 | 52 × 20 × 42 mm |
Hardware
1× 608 bearing · 1× M8 × 30 bolt + nyloc nut · 2× M5 × 10 screws + 2020 T-nuts
FIT CHECK
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
License
Original design by MakerCore Hub, free for personal and educational use under CC BY-NC 4.0. Remix it and share it with credit; contact us for commercial use.
Missions that use it
Upgrade Your 3D Printer to Klipper with MainsailOS
Faster, smoother prints with input shaping and pressure advance, controlled from a modern web UI.
EngineerFilament Dry Box with a Humidity Monitor
Wet filament causes stringing and weak prints. Seal spools with desiccant and get an alert when humidity rises.
Technician
