Print settings
| Material | PLA |
|---|---|
| Layer height | 0.2 mm |
| Infill | 20% |
| Supports | Not needed — prints flat as oriented |
| Filament | ≈ 4 g total (estimate) |
| Size · pico-mounting-plate | 33 × 63 × 6.5 mm |
Hardware
4× M2 × 5 mm screws
FIT CHECK
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
License
Original design by MakerCore Hub, free for personal and educational use under CC BY-NC 4.0. Remix it and share it with credit; contact us for commercial use.
Missions that use it
Microcontrollers: MicroPython on the Raspberry Pi Pico 2 W
Flash MicroPython, blink the onboard LED and read an analog sensor on a $7 board.
EngineerLine-Following Robot with Raspberry Pi Pico
Infrared sensors spot a black line and a $7 microcontroller steers the robot along the track.
TechnicianAutomatic Plant Watering with Raspberry Pi Pico
Measure soil moisture and run a small pump only when your plant is thirsty.
Technician
