Print settings
| Material | PETG / ASA |
|---|---|
| Layer height | 0.2 mm |
| Infill | 20% |
| Supports | Not needed — prints flat as oriented |
| Filament | ≈ 19 g total (estimate) |
| Size · wind-vane-608 | 192.8 × 34 × 64 mm |
Hardware
1× 608 bearing · M8 bolt · 2× M8 nuts (counterweight, add washers to balance) · 1× 6 × 3 mm magnet
FIT CHECK
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
License
Original design by MakerCore Hub, free for personal and educational use under CC BY-NC 4.0. Remix it and share it with credit; contact us for commercial use.
Missions that use it
Weather Station with a Live Web Dashboard
Log temperature, humidity and pressure every minute and view charts from any device on your network.
TechnicianWind Speed and Small Wind Turbine Power Logger
Measure wind with a cup anemometer and the power from a small hobby turbine side by side, and find out if wind makes sense where you live.
Engineer
