Print settings
| Material | PETG |
|---|---|
| Layer height | 0.2 mm |
| Infill | 100% |
| Supports | Not needed — prints flat as oriented |
| Filament | ≈ 1 g total (estimate) |
| Size · filament-spool-clip | 40.6 × 9 × 6 mm |
Hardware
None
FIT CHECK
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
License
Original design by MakerCore Hub, free for personal and educational use under CC BY-NC 4.0. Remix it and share it with credit; contact us for commercial use.
Missions that use it
Filament Dry Box with a Humidity Monitor
Wet filament causes stringing and weak prints. Seal spools with desiccant and get an alert when humidity rises.
TechnicianFilament Spool Scale: Know How Much Is Left
A load cell under your spool holder reports the grams of filament left in Home Assistant before you start a long print.
Technician
