Print settings
| Material | PETG / TPU |
|---|---|
| Layer height | 0.2 mm |
| Infill | 40% |
| Supports | Not needed — prints flat as oriented |
| Filament | ≈ 4 g total (estimate) |
| Size · gps-mast-m3-standoff | 28 × 28 × 50 mm |
Hardware
1× M3 × 8 mm screw · double-sided foam tape · 1 zip tie
FIT CHECK
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
License
Original design by MakerCore Hub, free for personal and educational use under CC BY-NC 4.0. Remix it and share it with credit; contact us for commercial use.
Missions that use it
Raspberry Pi Companion Computer for an ArduPilot Drone
Connect a Pi to the flight controller over MAVLink, read telemetry and send autonomous commands from Python.
CommanderWi-Fi Telemetry Ground Station for ArduPilot
Route MAVLink from your drone's companion Pi to QGroundControl on a laptop, phone or tablet at the same time.
EngineerBuild Your First 5-Inch FPV Drone
Frame, motors, flight controller stack, ExpressLRS radio and Betaflight setup — a complete first quad build.
Engineer
