Print settings
| Material | PETG / ASA |
|---|---|
| Layer height | 0.2 mm |
| Infill | 25% |
| Supports | Not needed — prints flat as oriented |
| Filament | ≈ 67 g total (estimate) |
| Size · soldering-iron-stand-sponge-tray | 130 × 103 × 64 mm |
Hardware
Cellulose sponge or brass wool · 4 rubber feet (optional)
FIT CHECK
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
License
Original design by MakerCore Hub, free for personal and educational use under CC BY-NC 4.0. Remix it and share it with credit; contact us for commercial use.
