Print settings
| Material | PETG / TPU 95A |
|---|---|
| Layer height | 0.2 mm |
| Infill | 100% |
| Supports | Not needed — prints flat as oriented |
| Filament | ≈ 3 g total (estimate) |
| Size · box-cable-grommet-20mm | 30 × 30 × 11.4 mm |
| Size · box-blank-plug-20mm | 30 × 30 × 11.4 mm |
Hardware
20 mm step drill or hole saw · silicone for a splash-proof seal
FIT CHECK
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
License
Original design by MakerCore Hub, free for personal and educational use under CC BY-NC 4.0. Remix it and share it with credit; contact us for commercial use.
Missions that use it
Weather Station with a Live Web Dashboard
Log temperature, humidity and pressure every minute and view charts from any device on your network.
TechnicianSolar LoRa Sensor Node for Far Fields
Send soil and weather readings kilometers away on a tiny battery recharged by the sun.
EngineerGarage Door 'Left Open' Alert
A magnetic reed switch and a tiny ESP32 tell your phone when the garage stays open after dark.
Recruit
