Print settings
| Material | ASA / PETG |
|---|---|
| Layer height | 0.2 mm |
| Infill | 40% |
| Supports | Not needed — prints flat as oriented |
| Filament | ≈ 24 g total (estimate) |
| Size · solar-panel-tilt-base | 70 × 24 × 64 mm |
| Size · solar-panel-tilt-arm | 134 × 52 × 5 mm |
Hardware
Per side: 2× M5 × 16 bolts + nyloc nuts · 2× M4 screws for the panel frame · 2× #8 / M4 screws for the roof or post
FIT CHECK
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
License
Original design by MakerCore Hub, free for personal and educational use under CC BY-NC 4.0. Remix it and share it with credit; contact us for commercial use.
Missions that use it
Off-Grid Solar-Powered Raspberry Pi
Size a panel, charge controller and LiFePO4 battery to keep a Pi project running 24/7 with no outlet.
EngineerDual-Axis Solar Tracker with Light Sensors
Four light sensors and two servos keep a small solar panel pointed at the Sun all day — then measure how much extra energy you gain.
EngineerSolar LoRa Sensor Node for Far Fields
Send soil and weather readings kilometers away on a tiny battery recharged by the sun.
Engineer
