Print settings
| Material | PETG |
|---|---|
| Layer height | 0.2 mm |
| Infill | 20% |
| Supports | Not needed — prints flat as oriented |
| Filament | ≈ 8 g total (estimate) |
| Size · rc-receiver-box | 66 × 34 × 17 mm |
| Size · rc-receiver-box-lid | 46 × 34 × 5 mm |
Hardware
2× M3 screws · a dab of silicone around the cable exit for wet runs
FIT CHECK
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
License
Original design by MakerCore Hub, free for personal and educational use under CC BY-NC 4.0. Remix it and share it with credit; contact us for commercial use.
Missions that use it
Upgrade a Cheap Toy RC Car with an ESP32
Replace the toy's receiver board with an ESP32 and a motor driver and drive it from your phone over Wi-Fi.
TechnicianAutonomous GPS RC Boat with ArduPilot Rover
Plan waypoints on a map and let your boat survey a lake or canal on its own.
CommanderRC Car Speedometer and Battery Telemetry on Your Phone
A magnet, a Hall sensor and an ESP32 measure real speed and pack voltage and stream them to a web page.
Technician
