Print settings
| Material | PLA / PETG |
|---|---|
| Layer height | 0.2 mm |
| Infill | 20% |
| Supports | Not needed — prints flat as oriented |
| Filament | ≈ 7 g total (estimate) |
| Size · pi-zero-slim-case-base | 69.8 × 34.8 × 4.1 mm |
| Size · pi-zero-slim-case-lid | 69.8 × 34.8 × 10.5 mm |
Hardware
4× M2.5 × 10 mm screws (from below into the lid posts)
FIT CHECK
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
License
Original design by MakerCore Hub, free for personal and educational use under CC BY-NC 4.0. Remix it and share it with credit; contact us for commercial use.
Missions that use it
Pi-hole: Block Ads and Trackers on Your Whole Network
A tiny DNS server that filters ads for every phone, TV and laptop in the house.
RecruitPlug-and-Play Retro TV Console with a Pi Zero 2 W
A console smaller than a candy bar that hides behind the TV — plug in power and two controllers and play.
RecruitPocket Retro Handheld with a Pi Zero 2 W
A Game Boy-style handheld with a small screen and real buttons wired straight to the GPIO pins.
Engineer
