Print settings
| Material | PETG / ASA (black) |
|---|---|
| Layer height | 0.16 mm |
| Infill | 25% |
| Supports | Not needed — prints flat as oriented |
| Filament | ≈ 6 g total (estimate) |
| Size · camera-module-3-case-front | 30 × 44 × 15 mm |
| Size · camera-module-3-case-back | 30 × 33 × 4.5 mm |
Hardware
4× M2 × 12 mm screws (self-tap into the front posts) · 1× 1/4"-20 hex nut (slides in from the side)
FIT CHECK
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
License
Original design by MakerCore Hub, free for personal and educational use under CC BY-NC 4.0. Remix it and share it with credit; contact us for commercial use.
Missions that use it
Motion-Alert Camera That Sends Photos to Your Phone
Detect motion with Picamera2 and OpenCV, save snapshots and push instant notifications.
TechnicianPi Zero Camera That Records Motion Clips to Your NAS
A small, cheap camera that saves a video clip — including the seconds before the motion — straight to a network share.
TechnicianSky and Storm Time-Lapse Camera
Capture clouds, sunsets and storms every few seconds and render a smooth video.
Recruit
