Print settings
| Material | PLA / PETG |
|---|---|
| Layer height | 0.2 mm |
| Infill | 20% |
| Supports | Not needed — prints flat as oriented |
| Filament | ≈ 21 g total (estimate) |
| Size · pi-4-5-case-base | 90.4 × 61.4 × 5 mm |
| Size · pi-4-5-case-vented-lid | 90.4 × 61.4 × 22 mm |
Hardware
4× M2.5 × 12 mm screws (from below, through the base and board into the lid posts) · 4 stick-on rubber feet
FIT CHECK
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
License
Original design by MakerCore Hub, free for personal and educational use under CC BY-NC 4.0. Remix it and share it with credit; contact us for commercial use.
Missions that use it
Install Raspberry Pi OS with Raspberry Pi Imager
Flash the operating system and pre-configure Wi-Fi, user and SSH before the first boot.
RecruitPi-hole: Block Ads and Trackers on Your Whole Network
A tiny DNS server that filters ads for every phone, TV and laptop in the house.
RecruitHome Assistant on Raspberry Pi 5: Your Smart Home Brain
Install Home Assistant OS and control lights, plugs and sensors locally — no cloud required.
Recruit
