Print settings
| Material | PLA / PETG |
|---|---|
| Layer height | 0.2 mm |
| Infill | 20% |
| Supports | Not needed — prints flat as oriented |
| Filament | ≈ 50 g total (estimate) |
| Size · project-box-medium-110x75 | 132 × 75 × 40 mm |
| Size · project-box-medium-lid | 110 × 75 × 5.4 mm |
Hardware
4× M3 × 12 mm flat-head screws · 2 wall screws
FIT CHECK
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
License
Original design by MakerCore Hub, free for personal and educational use under CC BY-NC 4.0. Remix it and share it with credit; contact us for commercial use.
Missions that use it
ESPHome Room Sensor: Temperature, Humidity and Motion
Build a $20 Wi-Fi sensor with an ESP32 and add it to Home Assistant with a few lines of YAML.
TechnicianAutomatic Plant Watering with Raspberry Pi Pico
Measure soil moisture and run a small pump only when your plant is thirsty.
TechnicianGarage Door 'Left Open' Alert
A magnetic reed switch and a tiny ESP32 tell your phone when the garage stays open after dark.
Recruit
