Print settings
| Material | PETG |
|---|---|
| Layer height | 0.2 mm |
| Infill | 20% |
| Supports | Not needed — prints flat as oriented |
| Filament | ≈ 102 g total (estimate) |
| Size · project-box-large-160x110 | 182 × 110 × 55 mm |
| Size · project-box-large-lid | 160 × 110 × 5.4 mm |
Hardware
4× M3 × 12 mm flat-head screws · 2 wall screws · cable glands or the printed 20 mm plugs
FIT CHECK
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
License
Original design by MakerCore Hub, free for personal and educational use under CC BY-NC 4.0. Remix it and share it with credit; contact us for commercial use.
Missions that use it
Hydroponics Controller: Pumps, Lights and Alerts
Schedule grow lights and nutrient pumps, monitor climate and get alerts when something drifts.
EngineerGreenhouse Climate Controller with Automatic Fan
Keep a small greenhouse from overheating: a fan turns on above your target temperature and humidity.
TechnicianSurvive Power Outages: UPS HAT with Safe Shutdown
Keep your Pi server running through short outages and shut it down cleanly before the battery runs out.
Technician
