Print settings
| Material | PLA / PETG (light colour) |
|---|---|
| Layer height | 0.2 mm |
| Infill | 20% |
| Supports | Not needed — prints flat as oriented |
| Filament | ≈ 6 g total (estimate) |
| Size · plant-label-stakes-4x | 110.8 × 103 × 2.4 mm |
Hardware
Paint marker
FIT CHECK
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
License
Original design by MakerCore Hub, free for personal and educational use under CC BY-NC 4.0. Remix it and share it with credit; contact us for commercial use.
Missions that use it
Automatic Plant Watering with Raspberry Pi Pico
Measure soil moisture and run a small pump only when your plant is thirsty.
TechnicianPlant Disease Classifier with a TensorFlow Lite Model
Point the camera at a leaf and an image-classification model tells you if it looks healthy or shows signs of a common disease.
Engineer
