Print settings
| Material | PLA / PETG |
|---|---|
| Layer height | 0.2 mm |
| Infill | 20% |
| Supports | Not needed — prints flat as oriented |
| Filament | ≈ 6 g total (estimate) |
| Size · pi-zero-camera-case-lid | 69.8 × 34.8 × 13.9 mm |
Hardware
Base from the Pi Zero Slim Case · 4× M2 × 4 mm screws for the camera · 4× M2.5 × 10 mm screws · Zero camera ribbon (short)
FIT CHECK
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
License
Original design by MakerCore Hub, free for personal and educational use under CC BY-NC 4.0. Remix it and share it with credit; contact us for commercial use.
Missions that use it
Pi Zero Camera That Records Motion Clips to Your NAS
A small, cheap camera that saves a video clip — including the seconds before the motion — straight to a network share.
TechnicianMotion-Alert Camera That Sends Photos to Your Phone
Detect motion with Picamera2 and OpenCV, save snapshots and push instant notifications.
TechnicianPi Zero Drone Camera and GPS Flight Logger
Record 1080p video automatically on power-up and log your GPS track for mapping later.
Engineer
