Print settings
| Material | PETG |
|---|---|
| Layer height | 0.16 mm |
| Infill | 40% |
| Supports | Not needed — prints flat as oriented |
| Filament | ≈ 1 g total (estimate) |
| Size · n20-motor-clamp | 30 × 12 × 14.3 mm |
Hardware
1× M2 × 6 mm screw (lock) · 2× M2 screws + nuts
FIT CHECK
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
License
Original design by MakerCore Hub, free for personal and educational use under CC BY-NC 4.0. Remix it and share it with credit; contact us for commercial use.
Missions that use it
Mini-Sumo Robot with a Raspberry Pi Pico
Build a small, low, pushing robot that finds its opponent with ultrasound and stays inside the ring using edge sensors.
EngineerLine-Following Robot with Raspberry Pi Pico
Infrared sensors spot a black line and a $7 microcontroller steers the robot along the track.
TechnicianSelf-Balancing Robot with a Pico and a PID Controller
A two-wheeled robot that stays upright by reading an IMU hundreds of times per second — control theory you can see.
Commander
