Print settings
| Material | PETG |
|---|---|
| Layer height | 0.2 mm |
| Infill | 100% |
| Supports | Not needed — prints flat as oriented |
| Filament | ≈ 24 g total (estimate) |
| Size · mini-sumo-scoop-blade | 96 × 46 × 18 mm |
Hardware
2× M3 × 10 mm screws + nuts
FIT CHECK
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
License
Original design by MakerCore Hub, free for personal and educational use under CC BY-NC 4.0. Remix it and share it with credit; contact us for commercial use.
