Print settings
| Material | PETG |
|---|---|
| Layer height | 0.2 mm |
| Infill | 40% |
| Supports | Not needed — prints flat as oriented |
| Filament | ≈ 16 g total (estimate) |
| Size · mini-submersible-pump-tank-bracket | 29.5 × 110 × 24 mm |
Hardware
2 zip ties
FIT CHECK
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
License
Original design by MakerCore Hub, free for personal and educational use under CC BY-NC 4.0. Remix it and share it with credit; contact us for commercial use.
Missions that use it
Automatic Plant Watering with Raspberry Pi Pico
Measure soil moisture and run a small pump only when your plant is thirsty.
TechnicianHydroponics Controller: Pumps, Lights and Alerts
Schedule grow lights and nutrient pumps, monitor climate and get alerts when something drifts.
EngineerAquarium Monitor: Water Temperature and pH
Watch your fish tank's temperature and pH from your phone and get warned before a heater fails or the water turns acidic.
Technician
