Print settings
| Material | PETG / ASA |
|---|---|
| Layer height | 0.2 mm |
| Infill | 40% |
| Supports | Not needed — prints flat as oriented |
| Filament | ≈ 13 g total (estimate) |
| Size · garden-sensor-stake-cable-channel | 199 × 36 × 10 mm |
Hardware
M3 screws or zip ties for the sensor box
FIT CHECK
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
License
Original design by MakerCore Hub, free for personal and educational use under CC BY-NC 4.0. Remix it and share it with credit; contact us for commercial use.
Missions that use it
Automatic Plant Watering with Raspberry Pi Pico
Measure soil moisture and run a small pump only when your plant is thirsty.
TechnicianSolar LoRa Sensor Node for Far Fields
Send soil and weather readings kilometers away on a tiny battery recharged by the sun.
EngineerGreenhouse Climate Controller with Automatic Fan
Keep a small greenhouse from overheating: a fan turns on above your target temperature and humidity.
Technician
