Print settings
| Material | PETG / PLA (white) |
|---|---|
| Layer height | 0.2 mm |
| Infill | 20% |
| Supports | Not needed — prints flat as oriented |
| Filament | ≈ 18 g total (estimate) |
| Size · esp32-sensor-wall-plate-single-gang | 70 × 115 × 9 mm |
Hardware
2× #6-32 flat-head screws · double-sided tape for the boards · low-voltage (5 V) wiring only
FIT CHECK
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
License
Original design by MakerCore Hub, free for personal and educational use under CC BY-NC 4.0. Remix it and share it with credit; contact us for commercial use.
Missions that use it
ESPHome Room Sensor: Temperature, Humidity and Motion
Build a $20 Wi-Fi sensor with an ESP32 and add it to Home Assistant with a few lines of YAML.
TechnicianHome Assistant on Raspberry Pi 5: Your Smart Home Brain
Install Home Assistant OS and control lights, plugs and sensors locally — no cloud required.
RecruitmmWave Presence Sensor: Lights That Know You're Still There
Unlike PIR, a 24 GHz radar sensor detects people sitting still, so lights stop turning off while you read.
Technician
