Print settings
| Material | PLA |
|---|---|
| Layer height | 0.16 mm |
| Infill | 20% |
| Supports | Not needed — prints flat as oriented |
| Filament | ≈ 12 g total (estimate) |
| Size · epaper-213-frame | 78 × 43 × 5 mm |
| Size · epaper-213-back | 78 × 43 × 2 mm |
| Size · epaper-213-desk-foot | 62 × 26 × 11 mm |
Hardware
4× M2 × 8 mm screws (self-tap into the frame)
FIT CHECK
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
Printers vary. If holes are tight, drill them out or add 0.2 mm in the .scad file. Board dimensions follow the makers' published drawings; check yours before a long print.
License
Original design by MakerCore Hub, free for personal and educational use under CC BY-NC 4.0. Remix it and share it with credit; contact us for commercial use.
Missions that use it
E-Paper Smart Badge and Desk Dashboard
A screen that uses power only when it changes: name badge by day, weather and calendar on your desk by night.
TechnicianTonight's Sky: Moon Phase and Planet Finder on E-Paper
A low-power e-paper frame that shows the Moon's phase and which planets are up tonight, calculated on the Pi with Skyfield.
Technician
